Universal Bender

This universal bender is the first reasonably priced thing I've seen that will turn my aluminium strips into something useful, reasonably efficiently. Perhaps I'll buy one. That's not the only useful thing on the site: I would like these Stevenson's metric blocks too.

Popular posts from this blog

Acrylic aquarium goodness

Image
I got my acrylic tank on Monday. theplasticpeople.co.uk deserve a link, because it looks great, and they were very helpful. It wasn't cheap, but it was still cheaper than the low iron glass. It looks even better. You would think that 10mm of acrylic would look a bit chunky, but it just doesn't. Perhaps its the clarity. The corners look perfect, basically because they are. It now seems really silly I was so determined to have rounded corners. I may eventually find it scratches easily, but for now I'm going to enjoy it. I've done some aqua-scaping and put the plants in. They are mostly unscathed. I got 5 bunches of Egeria densa with a bulk discount, and they do look a little worse for wear. It was hardest to ensure good light for them. I bought most of my plants from www.gardenandleisure.com . Its certainly the cheapest place to buy the Tropica range of plants, and they did a good job of the packaging. I've now found www.plantedtanks.co.uk who have an amazing ra...
Read more

It's been a long time, but check out the Electric Gerbil

Image
I'm building a robot - one of these ball robots that seem popular at the moment. I've actually experimented quite a bit already. I found this project , which I like, because it allows the robot to spin on the spot. I have in mind that this might be an entertaining toy for a child. I also like the idea you can kick it! It's called Kickbot. Anyway, I've got something that works mechanically, up to a point: it rolls along a bit jerkily, and spins around very nicely indeed! There are a few problems to solve: The jerky movement, and the overall strength. I need some way to link the two axles into a single, non bending axle. I also suspect I need something like Kickbot's hubs. I don't have a way to machine parts however. I had thought I might buy an aluminium tube with an internal diameter matching the a set of bearings, then push the bearings in. I need one at each end, and two in the middle. This has the advantage that the bearings will be well aligned, and th...
Read more

Fish!

Image
My aquarium project has been progressing slowly, but finally I have some fish. I've actually had some shrimp along the way, too. Any way, straight to a couple of photos: These are Danio erythromicron : cross banded danios. They are very shy and move quicky. They are extremely difficult to photograph. I choose them because they like reasonably hard, alkaline water, and that's what I've got. They are also beautiful - the photos don't do them justice. I'm hoping they will be a little more relaxed in a few weeks. I've got a dozen of them for now. More than this is recommended, but I think I'll buy something different next. Perhaps something a little less up tight, and more visible. I've added some more plants, and used some taller, but more sparse planting in the middle ground to try and draw them out where I can see them. This does seem to work. I've also got some shrimp. They are cherry shrimp, but they are a little disappointing to be honest...
Read more